FAQs Frequently Asked Questions About our Products and Solutions

Submit an enquiry Submit an enquiry

All FAQs (1832 total: showing 761-780)

What can be done if a memory card is not being completely filled with data?
Is there a way of configuring the FTP, HTTP, and Telnet services remotely on a CR1000 or CR3000 with an NL115?
Where can the MAC (physical) address of an NL115 be found?
Does an NL115 need a dynamic or static IP?
What is an alternative to using an NL115 or CFM100 and storing data to a card?
Using PC200W, how can a CR1000 be instructed to send data to the SC115?
Is it possible to automatically encrypt the data stored on an SC115?
Can the SC115 be used with an NL115 2 GB card to increase the storage capacity to 4 GB?
What is needed to have the data logger automatically download data to the SC115?
How can the SC115 be used?
After remotely uploading an operating system, how can the NL201 be reset?
Can the operating system (OS) in an NL201 be updated remotely?
What are the calibration procedures for the CSAT3A, CSAT3AH, CSAT3B, and CSAT3BH, and how are they traceable to the National Institute of Standards and Technology (NIST)?
Is the crosswind correction applied to the raw data of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
Are there any corrections to the raw data (not the average data) obtained by the CSAT3/3A/3AH?
Can the CSAT3/3A/3AH give a time stamp with each measurement value?
What is the direction definition of vertical wind speed for a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH? For example, does a negative value mean upward or downward?
What should be done if the CSAT3/3A/3AH cannot be found in the Short Cut list of sensors?
Are there any data logger programming changes that must be made to a program when using a long Synchronous Device for Measurement (SDM) cable with a CSAT3?
Can a CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH be used to measure wind flow angle, horizontal angle, and wind speed for the purpose of power curve testing?

Previous Next